Set Support Parameters¶
Select the model in need of support, than click 
on the Support interface and modify parameters to support.
Caution
Note that gradually increase / decrease parameters by 0.05 mm each time, or the print may fail.
Adjust the Pillar of Support¶
Sometimes the removal of supports might be tricky, in this case, adjusting Support Pillar helps.
Caution
Ba cautious in adjusting parameters. Aware that the model may fell during printing process when the adherence is too low.
there are 4 settings related to support pillar. Let's discuss them one by one.
Support Diameters¶
Here lists main differences between those diameters.
Col
Common Support Middle Diameter
It reflects the diameter of support pillars.
Col
Common Support Middle Diameter
It reflects the diameter of support pillars.
Col
Common Support Middle Diameter
It reflects the diameter of support pillars.
When diameters above increase, the support becomes more stable and the removal becomes harder; when they decrease, the support becomes less adhesive and the removal becomes easier.
Lift Height and Spacing¶
Col
Lift Height
The minimum distance between model and printing platform.
Col
Spacing
The minimum distance between adjacent support pillars.
When the Lift Height or Spacing decrease, the support becomes more stable and the removal becomes harder; when they increases, the support becomes less adhesive and the removal becomes easier.
Reinforce Support¶
Col
Col
① Reinforce Support: Add tree branch shaped connections between adjacent support pillars.
② Support With no Reinforce: The firmness of support drops significantly.
It is enabled by default for its strongly improving the strength of support.
Adjust the Base of Support¶
Base Type¶
Projection Base is set as the default base type, however, you may replace it with the one more adapting to the application.
There are 4 base types provided for selection:
Col
No Base
The layers adhering on the platform are pieces of supports.
Col
Bounding Box Base
The base covers the platform with a rectangular piece.
Col
Projection Base (default)
The base achieves the balance between material consumption and adhesion by covering the platform with the piece which expands the contact area.
Col
Outer Contour Base
The base covers the platform with the out contour shaped piece.
Base Height¶
Col
Col
It is the thickness of the base.
When the thickness is proper, it can be easier to remove prints by the cocked edge of the base.
Base Only¶
After checking this option, the printing model cling to the printing platform only with a base. This function is turned off by default.
Save Support Parameters¶
Col
Col
You can click Generate to preview customized support. When capturing a satisfied preview, click 
to save the setting with a new name.
To call out a support parameter profile saved previously, click 
and select from the list.